Tests for trends in time series

Vyacheslav Lyubchich

2022-02-22

1 Introduction

The majority of studies focus on detection of linear or monotonic trends, using

typically under the assumption of uncorrelated data.

There exist two main problems:

These problems can be addressed by using tests for non-monotonic trends assuming that observations can be autocorrelated.

set.seed(777)
n <- 100
Time <- c(1:n)
X0 <- arima.sim(list(order = c(1, 0, 0), ar = 0.5), n = n, n.start = 100, sd = 0.5)
X1 <- 2*Time/n + X0
X2 <- 2*(Time/n)^0.5 + X0
X3 <- 0.5*(Time - n/2)/n - 6*((Time - n/2)/n)^2 + X0
X <- as.data.frame(cbind(X0, X1, X2, X3))

The time series above were simulated:
A) X1 with linear trend,
B) X2 with square root – nonlinear monotonic – trend, and
C) X3 with quadratic – nonlinear non-monotonic – trend,
with stationary autocorrelated innovations X0: \(X0_t = 0.5X0_{t-1} + e_t\), where \(e_t \sim N(0, 0.5^2)\).

Let’s test these time series using the functions from package funtimes, using significance level \(\alpha = 0.05\).

To install and load the package, run

install.packages("funtimes")
library(funtimes)

2 Testing for presence of a trend

Function notrend_test tests the null hypothesis of no trend against different alternatives defined by the corresponding tests.

2.1 Linear trend

Consider the following pair of hypotheses
\(H_0\): no trend
\(H_1\): linear trend
that can be tested specifically using t-test.

Assuming the time series may be autocorrelated (which is the usual case with observational data), we apply sieve-bootstrap version of the t-test, by adapting the approach of Noguchi, Gel, and Duguay (2011):

notrend_test(X0)
# 
#   Sieve-bootstrap Student's t-test for a linear trend
# 
# data:  X0
# Student's t value = -2.6429, p-value = 0.098
# alternative hypothesis: linear trend.
# sample estimates:
# $AR_order
# [1] 1
# 
# $AR_coefficients
#     phi_1 
# 0.4212756

The large \(p\)-value correctly indicates that there is not enough evidence to reject the hypothesis of no trend in X0 in favor of the alternative hypothesis of a linear trend.

For the other time series, \(p\)-values are reported below:

apply(X[,-1], 2, function(x) notrend_test(x)$p.value)
#    X1    X2    X3 
# 0.000 0.002 0.858

indicating that the null hypothesis of no trend could be rejected and hypothesis of a linear trend could be accepted for X1 and X2. While X3 has a trend (based on the way it was simulated and the time series plot above), the alternative hypothesis of a linear trend does not fit in this case, so the test for linear trend (t-test) failed to reject the null hypothesis.

2.2 Monotonic trend

Since a linear trend is also a monotonic trend, we may expect seeing similar results when testing the following pair of hypotheses
\(H_0\): no trend
\(H_1\): monotonic trend
using Mann–Kendall test.

Apply Mann–Kendall test, also with the sieve-bootstrap enhancement for potentially autocorrelated data; \(p\)-values are shown below:

apply(X, 2, function(x) notrend_test(x, test = "MK")$p.value)
#    X0    X1    X2    X3 
# 0.057 0.000 0.000 0.929

indicating that the null hypothesis of no trend could be rejected and hypothesis of a monotonic trend could be accepted for X1 and X2. For X0 and X3, the null hypothesis could not be rejected, because X0 does not have a trend, and X3 has a trend that does not match the alternative hypothesis.

2.3 Any trend

If the interest is in testing for any, potentially non-monotonic trend, consider testing the following pair of hypotheses
\(H_0\): no trend
\(H_1\): any trend
using local regression-based WAVK test (Wang, Akritas, and Van Keilegom 2008).

Apply WAVK test, also with the sieve-bootstrap enhancement for potentially autocorrelated data:

apply(X, 2, function(x) notrend_test(x, test = "WAVK", 
                                     factor.length = "adaptive.selection")$p.value)
#    X0    X1    X2    X3 
# 0.337 0.000 0.026 0.004

The results indicate that WAVK test was correct in non-rejecting the null hypothesis for X0, and correctly rejected it for the time series with trends X1, X2, and X3.

Lyubchich, Gel, and El-Shaarawi (2013) originally implemented hybrid bootstrap to this test statistic, available from the wavk_test function described in the next section.

3 Testing a specific parametric form of trend

Function wavk_test is developed for the following goodness-of-fit question (Lyubchich, Gel, and El-Shaarawi 2013):
\(H_0\): trend is of form \(f(\theta,t)\)
\(H_1\): trend is not of form \(f(\theta,t)\)
where \(f\) belongs to a known family of smooth parametric functions, and \(\theta\) are its parameters.

Note Considering \(f(\theta,t)\) being some polynomial function, non-rejection of the null hypothesis means that function \(f(\theta,t)\) or its simpler form (lower-order polynomial) is sufficient for describing the trend in the tested time series.

Note The case of \(f(\theta,t) \equiv 0\) corresponds to testing for no trend (in other words, for a constant trend, same as in the previous section), and the following code differs only in the type of bootstrap used,

notrend_test(X0, test = "WAVK", factor.length = "adaptive.selection") # WAVK with sieve bootstrap
# 
#   Sieve-bootstrap WAVK trend test
# 
# data:  X0
# WAVK test statistic = 8.7024, moving window = 4, p-value = 0.37
# alternative hypothesis: (non-)monotonic trend.
# sample estimates:
# $AR_order
# [1] 1
# 
# $AR_coefficients
#     phi_1 
# 0.4212756
wavk_test(X0 ~ 0, factor.length = "adaptive.selection") # WAVK with hybrid bootstrap
# 
#   Trend test by Wang, Akritas, and Van Keilegom (bootstrap p-values)
# 
# data:  X0 
# WAVK test statistic = 0.30965, adaptively selected window = 4, p-value
# = 0.632
# alternative hypothesis: trend is not of the form X0 ~ 0.

To test a linear trend \(f(\theta,t) = \theta_0 + \theta_1 t\), use

wavk_test(X0 ~ t, factor.length = "adaptive.selection")
# 
#   Trend test by Wang, Akritas, and Van Keilegom (bootstrap p-values)
# 
# data:  X0 
# WAVK test statistic = -0.085378, adaptively selected window = 4,
# p-value = 0.98
# alternative hypothesis: trend is not of the form X0 ~ t.

Note that the time sequence t is specified automatically within the function.

For the other time series, \(p\)-values are shown below:

apply(X[,-1], 2, function(x) wavk_test(x ~ t, factor.length = "adaptive.selection")$p.value)
#    X1    X2    X3 
# 0.954 0.786 0.020

The function poly could also be used, for example, test quadratic trend \(f(\theta,t) = \theta_0 + \theta_1 t + \theta_2 t^2\) and show the trend estimates using the argument out = TRUE:

wavk_test(X3 ~ poly(t, 2), factor.length = "adaptive.selection", out = TRUE)
# 
#   Trend test by Wang, Akritas, and Van Keilegom (bootstrap p-values)
# 
# data:  X3 
# WAVK test statistic = -0.097613, adaptively selected window = 4,
# p-value = 0.896
# alternative hypothesis: trend is not of the form X3 ~ poly(t, 2).
# sample estimates:
# $trend_coefficients
# (Intercept) poly(t, 2)1 poly(t, 2)2 
#  -0.4860421  -0.2358495  -4.7102192 
# 
# $AR_order
# [1] 1
# 
# $AR_coefficients
#     phi_1 
# 0.4193298 
# 
# $all_considered_windows
#  Window WAVK-statistic p-value
#       4    -0.09761277   0.896
#       5    -0.47737630   0.816
#       7    -0.47880434   0.860
#      10    -0.12694875   0.780

Citation

This vignette belongs to R package funtimes. If you wish to cite this page, please cite the package:

citation("funtimes")
# 
# To cite package 'funtimes' in publications use:
# 
#   Vyacheslav Lyubchich and Yulia R. Gel (2022). funtimes: Functions for
#   Time Series Analysis. R package version 8.2.
# 
# A BibTeX entry for LaTeX users is
# 
#   @Manual{,
#     title = {funtimes: Functions for Time Series Analysis},
#     author = {Vyacheslav Lyubchich and Yulia R. Gel},
#     year = {2022},
#     note = {R package version 8.2},
#   }

References

Lyubchich, V., Y. R. Gel, and A. El-Shaarawi. 2013. “On Detecting Non-Monotonic Trends in Environmental Time Series: A Fusion of Local Regression and Bootstrap.” Environmetrics 24 (4): 209–26. https://doi.org/10.1002/env.2212.
Noguchi, K., Y. R. Gel, and C. R. Duguay. 2011. “Bootstrap-Based Tests for Trends in Hydrological Time Series, with Application to Ice Phenology Data.” Journal of Hydrology 410 (3): 150–61. https://doi.org/10.1016/j.jhydrol.2011.09.008.
Wang, L., M. G. Akritas, and I. Van Keilegom. 2008. “An ANOVA-Type Nonparametric Diagnostic Test for Heteroscedastic Regression Models.” Journal of Nonparametric Statistics 20 (5): 365–82.